SP Series PTZ camera + DVR + Controller (SP_TX) setup

1. Wiring
-Junction Box(DVR+, - terminal)------two Conduct Wire-------DVR (RS 485 +,-)
-Junction Box (Data port) Data Cable Comes with controller (DATA port)

2. Junction Box Setting
-Open the Junction Box and change two “Jumper Cable” from RS 232 to RS 485

3. Controller Setting
-Hit ‘11’ and hold “Sel” until it goes into setup
-Protocol : TPRO210 (This is equivalent to PELCO D)
( Pelco P is different from Pelco D)
-Master Baud Rate : 2400
-Slave Baud Rate: 2400
(Slave baud rate of controller should be same as DVR baud rate)
-Save & Exit

If you have two TX-SP (controller), please look at the below diagram.